Response for Bruce about 16 x 8 Weld

[little_wiley]

Bruce,

 

 Received your email but no return address.  I have the Weld 16x8 SSR's with a 4 5/8 offset if I remember correctly and am running 285/75R16 BFG's.  Once I put it togather, I did have problems with scraping :angry: .  I raised the torsion bars and solved some of the problems but depending on what I was doing, still had scraping ??? .  If I hit a bump on a dirt road or turned around by driving down in the ditch, it scrapped the wheel well.

 

I finally said the heck with it and installed a RCD 6" suspension lift and love it :love: .  I hope the get some pic's put up shortly but seems not enough time in the day.

[SixthMan]

little_wiley,

 

Thanks for the quick response.  I wonder if the guys running 285's on the stock wheels have the same problems without a lift?  Maybe 3 5/8 backspacing?  Thanks again!

[little_wiley]

Take a look at the tire fitment guide below.  This may be just what you were looking fore.

 

http://www.natltire.com/ntw0799/pages/fithit.html