Jump to content

driveline squeak


Recommended Posts

ive got a 2001 2500HD CC 4X4 and at low speeds such as taking off from a stop there is a squeak comming from the driveshaft. the manual says use some #5786$^&^*5 lubricant on driveline and drivespline. has anyone else had this? do i take the driveshaft off and u-joints out and lube them all up? the slip yoke has a boot over it with metal bands closing it at each end. gotta cut those off and take all that off to lube that up as well or does anyone have an easier way to get this done?

Link to comment
Share on other sites

TXD........Are you talking squeek or clunk when taking off from a

dead stop? How many miles do you have?

 

If its a squeeking noise its prob. a u-joint going bad. The factory

cheapies don't have a lube zerk anymore ! So they usually crap

out about 60k or even sooner if you tow heavy or snowplow !

Link to comment
Share on other sites

I had the same noise coming from my driveshaft immediatly after I had my 6" lift installed. Drove me nuts because at first I though that the installers had left some loose bolts in the install. I finally had the driveshaft replacement put in for my 4x4 and it went away. Dont know why and sorry I dont have a better answer for you on how to fix it.

Link to comment
Share on other sites

  • 1 month later...

forgot to give all an update. 68,000+ miles on it. i took it in for the squeek and they said the slip yoke was binding and ruined the first u-joint. got both replaced under warranty. all is well again.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.