6.6L Gas 10 Speed Transmission Pan

64BAwagon · May 22

I tried several times to turn that pic 180 degrees. The funny part is that the file in my computer is correct but somehow when I copy it here its upside down, I finally gave up and figure you guys would see what I meant

bruceb58 · May 22

I kinda like the idea of the heat wrap. I wonder what the heat difference is between the uncovered pipe and the covered.

Edited May 22 by bruceb58

sno1 · May 22

Thank you. It's great of you guys to share your experience.

64BAwagon · May 22

9 hours ago, bruceb58 said:

I kinda like the idea of the heat wrap. I wonder what the heat difference is between the uncovered pipe and the covered.

I dont have a before and after for the heat wrap but this truck runs about 10 degrees cooler than my 2021 6 speed and the trucks were identical right down to the color.

Logic will tell you that a post cat pipe is gonna be pretty hot and that some of that heat is going to radiate into that pan. I monitor the cat temps on my Scangage and its common for them to be in the 1500 degree range while towing. Its likely not as bad with some air blowing under the truck but when its run hard and then shut off the heat is going to go up and the pan is whats above it.

bruceb58 · May 23

13 hours ago, 64BAwagon said:

I dont have a before and after for the heat wrap but this truck runs about 10 degrees cooler than my 2021 6 speed and the trucks were identical right down to the color.

Logic will tell you that a post cat pipe is gonna be pretty hot and that some of that heat is going to radiate into that pan. I monitor the cat temps on my Scangage and its common for them to be in the 1500 degree range while towing. Its likely not as bad with some air blowing under the truck but when its run hard and then shut off the heat is going to go up and the pan is whats above it.

Have a link to what you are using?