1995 Sierra 1500

Curl510 · February 6, 2023

Hello my fellow gmt400 brothers. I just got a 95 Sierra single cab roller, been looking for interchangeable parts. Found a 2004 Yukon denali donor. I’m already going to be taking motor and trans. What else from the vehicle is usable? Breaks suspension rear end gas tank etc? Thanks much appreciated

CamGTP · February 6, 2023

Basically nothing.

The suspension stuff would never swap over, completely different era of trucks and different frames. I highly doubt the fuel tank would bolt up.

You'll need the engine/transmission, wiring harness, fuse block, pedal assembly and the wiring for the throttle pedal if you plan to stick with drive by wire.

Curl510 · February 7, 2023

@CamGTP Ok was going to try testing out fitting the dash or some keep the cluster for gauges. Will be taking all wiring. I would like to go drive by cable route. Currently no motor in truck

Edited February 7, 2023 by Curl510

Curl510 · February 7, 2023

Thank u. Much appreciated for ur information

Edited February 7, 2023 by Curl510

CamGTP · February 8, 2023

If you want drive by cable you will have to make sure the computer you have has the IAC drivers on the circuit board. Then wire in the IAC/TPS to the computer and all that jazz.

Or you will have to source a P01 computer/harness and fuse block if you want drive by cable from the factory. 1999-2002 trucks used cable throttle bodies and 2003+ trucks used drive by wire.