Jump to content
  • Sign Up

Voltage out from K9 Body Control Module only 4V ?

Stig M
 Share

Recommended Posts

Stig M New Member

Stig M

Posted
Posted

Hi, I'm working with my new LED-bar which have a possibility to stay on during daytime with only positioning light. For this I was trying to get a 12V signal out of the K9 Body Control Module (BCM).

But, my measure instruments only shows 4 volt when Daytime Running Lamps (DRL) is switched on. Can this be correct? Anyone who have tested this before?
See enclosed picture of wiring diagram with yellow-marked the wire I measure on.

I might find a 4 volt relay somewhere on internet ( ? ), but want first to try find a solution with 12V relay.

Anyone maybe have other suggestions to get a 12V signal out when DRL is on?

Picture wiring diagram daytime running lamp.PNG

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept