Jump to content
  • Sign Up

Upfitter X7 AUX Switch Trigger wire

ctc4Chev
 Share

Recommended Posts

ctc4Chev New Member

ctc4Chev

Posted
Posted (edited)

Can anyone help? I have a 2016 diesel 2500HD and want to use the Upfitter X61A junction block - X7 plug/cable to run a lightbar.

I need to add my own switch to ground, to control the X7 power relays for switch 3. I have added for switch 3 the relay, 30amp and 5amp fuses in the X50A Fuse Block, installed the upfittter X7 plug and cable in the X61A Junction block.  The wiring schematic for the upfitter relays Page 396, has the trigger as X5-pin 11, however when I check the pins of the X61A Junction block -X5 pin schematic on page 593 pin 11 is assigned to "Lane Departure signal".  I need help finding the 85/86 relay wire to attach a ground switch.

Just a note: I plan on using pin 18 of the K9 Body control X5 plug as the ground.  This should control the lightbar to only have power when the High Beam are on. 

Upfitter Switch Schematic P396.PNG

X61A Junction Block P579.PNG

X5 Pins P593.PNG

Edited by ctc4Chev
spelling
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept