2018 Silverado issues - tried doing burnout and now runs bad and more... help!?

[Westwildcat]

I have a question I hope someone can help me with. I decided to try doing a burnout with my truck today for the first time. I did one for about 5-10 seconds, or tried to with some success. Now I have a check engine light and the truck runs like $h!t. Wont get up to highway speed and transmission doesnt shift properly. When at an idle it runs rough. I tried hooking the obd2 test tool to the truck under the dash, and two codes come up.

 

P228c - fuel pressure regulator

P0089 - fuel pressure regulator.

 

I tried the erase button and it did nothing. 

 

I attached 3 notifications I received when this happened.

 

I'm going to take the truck to dealership tomorrow.

 

Any ideas on what this is?

 

Will warranty be void since I was trying to do a burnout?

 

Any help or thoughts on my situation is appreciated.

 

Thanks

 

[MY164X4]

Warranty should cover it.
I wouldn't mention no burn out @ all.
Service rep isn't your friend


Sent from my iPad using Tapatalk

[BO TIE 1]

I have a question I hope someone can help me with. I decided to try doing a burnout with my truck today for the first time. I did one for about 5-10 seconds, or tried to with some success. Now I have a check engine light and the truck runs like $h!t. Wont get up to highway speed and transmission doesnt shift properly. When at an idle it runs rough. I tried hooking the obd2 test tool to the truck under the dash, and two codes come up.
 
P228c - fuel pressure regulator
P0089 - fuel pressure regulator.
 
I tried the erase button and it did nothing. 
 
I attached 3 notifications I received when this happened.
 
I'm going to take the truck to dealership tomorrow.
 
Any ideas on what this is?
 
Will warranty be void since I was trying to do a burnout?
 
Any help or thoughts on my situation is appreciated.
 
Thanks
 

Try disconnecting the battery for a while. It may reset.

[Paintor]

On a positive note, I have never heard of those codes popping up on a “power brake burnout”.

 

You may have brought up an issue that needs attention. I would not delete those codes.

[Frankielozano214]

Damn kinda like what I did first week I got my truck tried racing another truck ended up with a bad lifter it collapsed and start misfiring, well I ended up doing a afm delete and non afm cam and tune now it’s good, so what did it end up being?

[no12nv]

i disconected my pos term on bat for 30 secs on my old 15 touched it for like a split sec basically just sparked 1, 2 ,3 times then re connected. no codes n ran like it shud.