Jump to content
  • Sign Up

Plugs in truck bed?


Recommended Posts

Could someone tell me what these holes below rail of truck are for?  Some of them have plugs in them, ( assume that was when new).  Some have no plug, I don't see them being used for tie downs as there isn't a place to hook and sheet metal just too thin, would just bend.   If the plug has been removed, then the same plug was removed across on the other side of bed.  Somewhat concern about getting rock in there when I haul gravel/rock for landscaping, don't want to plug something up that might rust.  There are small holes on floor bed right behind cab, assume to drain water and I doubt rock will go down them unless I load pea gravel.   I do have one job for an underground drain I want to use pea gravel.  My old Dodge didn't have any holes like this. 

 

5cfda0460e455_SilveradoTruckBed.thumb.jpg.872092e4e752c7b659e539e6311b7090.jpg

 

Edited by Diverjer
Link to comment
Share on other sites

Okay, I see, they must push in there and then twist to tighten down.   The existing built in tie downs seem good enough for me.  You would have to take these out or some kind person would steal them.  I may see if I can buy plugs to put back in, but it looks like if rock did go in them, it would just fall on through. 

 

Thanks for the info, I can see that they could be handy for some things.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.