Jump to content

Recommended Posts

I buught a 2011 silverado 1500 5.3 with 130000 mi May . The oil became deluded with gas - I changed all 8 injectors with new Delco injectors. I'm still getting gas in the oil.  It runs good - fuel milage is about 14 mpg. Can there be a problem with the computer keeping the injectors open after the ignition is off? Would a diagnostic check at a GM dealer show a problem with injectors? 

PS the check engine light has not came on

 

 

 Thanks for any help

Sisu01

Link to comment
Share on other sites

Use a scanner, check fuel trim to be sure they are cycling around 0 and not high positive.

Use a mechanics stethoscope to check if each injector is clicking.

If not, use a noid light to see if injector signal is getting to the injector.

Link to comment
Share on other sites

The one question you asked, fuel after shut down?do you have a extended start?like, giving it some gas pedal to air it up?,or where is the black smoke out the tailpipe,what rpm?it should be noticable

Link to comment
Share on other sites

What's fuel trims? IF you have a bad O2 sensor it could be dumping fuel in the system but this sounds worse as if it's leaking fuel. 130k is to low for leaky rings, etc.

Have you did a clear flood crank? With the pedal pushed all the way to the floor and crank it and see if it has a steady crank sound.

IF you can create a video and upload the video to a free dropbox account and post a shared link here in the forums. We can listen to it then if you have someone to record while you perform the clear flood mode procedure.


IF it fires in clear flood mode then fuel is still getting thru.

Do you have a fuel pressure reading at idle and while driving? Running rough? Running it with fuel in the oil pan will cause premature engine wear due to the gas bring diluted and the stuff they use in it even though gas is made from .... Oil...

Let us know what you find.

The stethoscope method mentioned by the previous poster is a good first choice to try and inexpensive. I use that method a lot when checking for misses, etc...

Sent from my SM-N960U using Tapatalk

Link to comment
Share on other sites

It starts fine , runs fine ,never had a check engine light on. I have an appointment at the local Chevy dealer tomorrow for a diagnostic check. I did buy the truck used so it may be something the previous owner did  (computer performance upgrades ?).

Link to comment
Share on other sites

3 hours ago, Sisu01 said:

It starts fine , runs fine ,never had a check engine light on. I have an appointment at the local Chevy dealer tomorrow for a diagnostic check. I did buy the truck used so it may be something the previous owner did  (computer performance upgrades ?).

Was it a certified vehicle? Sometimes when you buy them from dealers they say they're "Certified". If so and it's a Chevy dealer if it turns out there's a tune on it or they say then ask them if they sold it to you if they checked for it as part of their "certification" process. 

 

I wouldn't mention a tune to them as they should be able to diag that by looking at software revisions. 

 

Sometimes looking for tsbs on issues like this can help as well. 

 

Also the last post asked a good question, is the dipstick high or low? Also I'm sure you changed the oil initially after the injector issue? If it was a fair amount I'd probably change it a time or two to get the fuel out of the system. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.