upfitter switch 2017 Silverado Texas edition Upfitter/Aux switch install

Jon DeLoach · April 13, 2019

here are some picture and videos of how i installed my upfitter aux switches to my 2017 silverado Texas edition truck which DID NOT com with them nor does it have the relays fuses or switch wires in the harness.

keep in mind the switches are GROUND or NEGATIVE switching. which means they DO NOT HAVE 12v ON THEM. DO NOT PUT 12V ON THE WIRES YOUR ABOUT TO INSTALL.

i had to get a new connector from a crashed truck in a junk yard which i then pulled 4 of the pins and wires out of to install into my trucks harness plug for the upfitter switch.

once i did that it was just a simple act of making a short extension wire from those 4 wires coming from the harness plug to go to the driver kick panel where im going to locate the relays for the devises i want to control.

you will see the harness plug and wires where i put them. and you will see the JST plug i used to connect the 4 wires to the extension wire to run to my relays. will also upload videos soon.

Jon DeLoach · April 13, 2019

Jon DeLoach · April 13, 2019

Weezy · April 30, 2019

Looks good. What type of controller did you use?

94yj · May 5, 2019

looks good where did you mount your 4 relays at?

njblazer · August 30, 2021

what size are the 4 pins you put into the back of the upfitter plug

Robo9831 · December 24, 2021

so i have a couple of idea on this. i would like to maybe retro fit one of these uplifter switch panel in the roof console. since my truck is fully loaded. so all my factory panel is all being used. so the ? i have the switch panel. how long is it and could the front finish trim come off. i dont have my truck with me. its at the shop.