"Cheap-@ss" Lower Deflector Mod

[BigBlueLB756]

What's not to love? Cost: ZERO!

 

 

For the end cuts,measure down from the top of the deflector 5 5/8", mark it and run your masking tape across to it from the center opening.

 

Happy cutting!

[dbbd1]

I haven't done this yet but if it's like my jeep, it will cut easier if you take a heat gun (or hair dryer) to it, just ahead of your razor blade.

[Heavy 5.7]

just ahead of your razor blade.

There is a Dremel tool on the ground in the picture.

[dbbd1]

Yep, noticed that but, I found it much easier with just a blade. And less messy.

[BigBlueLB756]

Wife keeps the driveway swept, so I didn't care about the mess!

[BigBlueLB756]

Nevermind.

Edited July 15, 2017 by BigBlueLB756

[BigBlueLB756]

Here's the original photo again:

[thebronze]

Looks great and def cheaper than $350-$450 for a PPV deflector!!  I would've gone maybe a little higher even.

BigBlue what did you use to deburr all the plastic stuff from the cuts?

[BigBlueLB756]

Everything I used is shown in the photo.  The cheezegrater and sandpaper block smooved it all out.

By the way, that mod saved me some bucks the other day when I pulled up to one of those downtown gutter curbs and still dragged a little.  

Edited June 16, 2019 by BigBlueLB756

[Dearmosd]

20min and I regained a couple inches that I needed after lowering the front end

 

 

Edited June 22, 2019 by Dearmosd

[BigBlueLB756]

"She's got the look,...."

[Texas Daddy]

This tool works great - took 10min...

Sent from my SM-G975U using Tapatalk

[Dearmosd]

Looks clean. I was worried that the vibrations were going to be too much and effect the lines of cut

[BigBlueLB756]

Affect?