Elite Engineering E2-X catch can

[Cale_H]

Elite Engineering E2-X catch can with clean-side separator. Has 11k miles on it, and I've upgraded the hoses to trans line so it wouldn't have the gas-smell bleed-thru that the thinner hoses can have. Located in Metter, GA.

 

Call or text (912) 245-4232

 

$275 Shipped

[Cale_H]

[Cale_H]

Bump

[Cale_H]

Bump

[Cale_H]

Bump

[Nasty]

I may be interested in this if I can't find the plug n play one

[Cale_H]

I may be interested in this if I can't find the plug n play one

OK.. This one already had the hoses cut to length, ready to be installed.. Won't take 15 minutes to install..I had it mounted right behind the washer tank

[Nasty]

How did you have it routed though. Because I have the escalade engine cover on and all the pictures I see of others the tube is laid on top of the intake manifold. And I have to route it under the cover if it'll fit or go over the throttle boddy

Pictures of how it was in your truck would be nice

[Cale_H]

How did you have it routed though. Because I have the escalade engine cover on and all the pictures I see of others the tube is laid on top of the intake manifold. And I have to route it under the cover if it'll fit or go over the throttle boddyPictures of how it was in your truck would be nice

As far as I can remember, none of my hoses went over the manifold..I had mine routed over the throttle body.. And sadly, I don't have any pictures of how I did mine

[Nasty]

Did you have stock air intake or aftermarket?

[Cale_H]

Did you have stock air intake or aftermarket?

 

I had it on the stock one to start with, then had it on an Airaid MIT..it comes with the adapter for one side of the stock intake, and the rubber cap for the other side..I'll have to look today, but I think I had to cut the cap to get it off my stock intake..I'll try to get another one if I did

[Cale_H]

SOLD.. Mods please delete