No Cutting Lift Kit to fit 33's

[2015Z71]

What is the best lift get to lift the truck enough to fit 33's with no rubbing, no wheel spaces or cutting of anything under the truck?

[soltys]

I may be mistaken but I believe that people are fitting 33's on them without lifts. 275/60/20s will fit without rubbing, lifting or spacing and a couple of members have been running them.

[2015Z71]

Interesting I was not aware you could run them with no lift. I would like a lift on my truck either way. So what is the best quality lift that requires no cutting.

[robvas]

How high do you want to go? If you just want a 2-2.5" level/lift pick any of them it doesn't matter. If you want to go like 6" that's where you have to do some research

[LongrangeLauber]

All lifts require you to cut or grind something from what I've seen glancing around

[2015Z71]

I like the look of the 4 inch lifts. 6 inch may be a little too much for what im doing with my truck. I also want to be able to fit 33x12.50x20 with no rubbing or spacers.

 

I am hoping there is something that does not require me to grind/weld or cut.

[20SierraL8T24]

Unless you go with a Rc 3.5, im pretty sure everything else requires cutting.

[LongrangeLauber]

Unless you go with a Rc 3.5, im pretty sure everything else requires cutting.

I wouldn't trust that kit IMHO

[20SierraL8T24]

I wouldn't trust that kit IMHO

Neither would I. I think these trucks look great with the level only.

[SgtShiv]

Without cutting my vote goes to leveling/lift kit in 2-2.5" range

[mdrew]

A 1.5 level is all you need, assuming the wheel offset is correct.

 

I'd really like to see a level that includes new A arms. When you jack the oe arms down, steering and ride quality suffer a bit.

[HondaHawkGT]

My setup is probably the minimum you'd need to run 33x12.50's. New UCA's, rear lift blocks and a leveling kit up front.

 

Edited September 19, 2015 by HondaHawkGT

[rookhoe]

You can run a 2 inch level in the front and a 0 offset wheel. That will allow you to run 33x12.50 without any cutting.

 

 

Sent from my iPhone using Tapatalk

[2015Z71]

Why do people not like the RC 3.5? And the 3.5 requires cutting.

Edited September 21, 2015 by 2015Z71

[JCD1976]

 

2-1/2" RC Level Kit, 20x9 OE Wheels, 305/55R-20(basically 33-12.50) Nitto G2's. No cutting

Edited September 21, 2015 by JCD1976