RC 2'' Levelling Kit Install

[cmh2001]

OK, so I'm installing my RC 2'' leveling kit today. I did the driver's side with out too much problems. I'm following the video on you tube for it from SnowmanJohnWV. On the pass. side I'm having alot of trouble getting the ball joint to come apart after beating on it with a hammer. Does anyone have any tips on how to make it come apart? I'm not sure what it is called but it is the the one at the top of the wheel, not the one for the tie rod.

[ruggedlife]

put on your big girl panties and it it, you aren't going to break anything. i typically use a 5lb mini sledge when i break ball joints loose.

[Silverado4x4]

I have put on 4 leveling kits for people and never broke the ball joints loose, just lossened the front sway bar from the "A" arm pin.

[cmh2001]

I went to Home Depot and bought a bigger hammer. Got it done.

[scott26]

Are you sure you have the sway bar lessened up enough? I know that was my issue.

 

Sent from my DROIDX

[BlackZ71Silverado]

I went to Home Depot and bought a bigger hammer. Got it done.

 

 

That's all you need, a BFH! Always gets the job done.