Search the Community
Showing results for tags 'shaft'.
Found 1 result
-
Well I ordered all the parts this morning to do the rear axle shafts and brake job. Truck has 81,XXX miles on it. Factory pads are about gone. The passenger side axle shaft seal is back to leaking pretty bad. It was R&R'd at 16k and has been sweating ever since and the dealer didn't want to hear it. 9 months later when I bought our new Enclave, I made sure I didn't step foot in that dealer. Anyway, I've also had the driveshaft balanced by a local shop which helped out quite a bit. All but one person who I've found did Yukon shafts said it fixed the vibration. So for $260, worth the old college try. Parts list en route are.... -Yukon Axle Shafts -ACDelco Wheel bearings (both sides) -ACDelco axle shaft seals (both sides) -GM Diff cover gasket (yes I know its reusable but I've already used it once with my PML Cover and put silicone on it. ) -Raybestos Police package rotors. I read that these are mill balanced to a pretty good spec. Tolerances in general are much tighter. -Raybestos hybrid ceramic truck pads While I have it apart I'm going to do a gear pattern check, R&P backlash check at multiple locations around the ring AND check the pinion pre-load measurement. I read that one of these lemon buy back vibrators was donated to a tech school and upon disassembly the pinion pre-load was zero. Yes, zero. So i'm going through the axle my way.
