Search the Community
Showing results for tags 'aluminum control arm'.
Found 2 results
-
I have a 2015 ltz z71 premium crew cab 1500 and was wandering if changing my lower control arms from the stock aluminum to the cast steel will affect the truck at all. Or if the two control arms are interchangeable below is the pic of what the control arms look like after I changed them out. Still have to add the washer but looks like they will work? Everything fits correctly other than the balljoint bolt length
-
Hi I’m new to the forum, so pardon any incorrect etiquette on my end. I have a 2014 Silverado 4x4 with aluminum LCA’s. After doing about a weeks worth of troubleshooting a loud squeak when turning the wheels, I did some investigating and learned that I most likely needed new lower ball joints. I ordered up some MOOG LBJ and some new tie rods as well. After the GRUELING process to get those ball joints out, and replaced, a week later... I HAD THE SQUEAK STILL. I look to the ball joint again, and the grease was spilling out of both of the brand new MOOG lbj boots. Listen... I’m not against saying that I might have been rough and ripped them upon installation... but at this point, I don’t care. So I ordered some brand new Lower Control Arms with LBJ’s in them already. Now finally, my question. Is there a way to install these Lower Control Arms without removing the entire wheel/hub assembly all over again? It looks like there are 6 bolts. I’m going off of memory. I have King OEM shocks that I’ve taken off countless times, so I know those are easy, I’m just looking for a quick way to get the job done. any help, helps! thank you for hearing my terrible story haha
