Search the Community
Showing results for tags 'Factory wheels'.
Found 2 results
-
I am looking to get a set of 2020 chevrolet 20" take-off rims to replace my factory 2006 Yukon Denali 17" wheels. My question is 2-fold. Do you guys think these should fit first of all? ...And secondly will my 06 GMC recognize the 2020 Chevrolet tpms sensor if I take it to have them reprogrammed?
-
I am sure this has been covered somewhere but figured wouldn’t hurt to just post some photos up because I couldn’t really find any. Background: 2017 GMC Sierra 1500 with the awful ranchos Has the zone 2 inch lower strut spacer then a .5 inch RC top spacer, the rear is factory. I have ran many different size tires (I work at a tire wholesaler so just have access to try them all) 275/55R20 Goodyear (factory) LT295/55R20 Cooper stt pro (Only had 2 inch level) LT295/60R20 Toyo MT (Added the extra .5) P305/55R20 Nitto Ridge Grappler u(rode amazing FYI) LT295/60R20 Nitto Ridge Grappler (Current set) All the above mentioned have scrubbed in some form or another and while being mounted to my factory 20 inch snowflakes. Sway bar and/or Stamped steel UCA. Current set rubbed both as far as I could tell. Anyways I decided to try out some 1/4 inch wheel spacers to see if that helped my problem and installed them tonight. Will check the rubbing out tomorrow. About talked myself out of them after reading stuff but there were more saying they were okay. From what I could tell I got 8 hand turns out of the lugs once the spacer was on then probably another 1.5 or 2 it seemed like when tightening them down. Snapped a could photos. If anyone needs anymore in daylight I can do that
