In the middle of an install and I've run into an issue. Tech support is closed until Monday. I'll call them Monday if all else fails, but hoping someone else may have run into this issue.
I have the steps installed and am at the point of hooking the blue and white wires from the OBD module to some wires behind the kick panel.
The issue I have is the instructions and pictures don't match what I have. I have confirmed the instructions I'm looking at are for my make/model.
The instructions say I should have an 8 plug harness....while I have only 7 plugs.
The instructions say I should connect to the first, gray plug....my first plug is white.
The instructions say I should connect to the 4th, green plug.....my 4th plug is black. Even if I use the green plug, the wire color and the specified pin location does not match the wire color specified in the instructions.
Hopefully someone else here has run into this same issue and can confirm which plugs/wires I'm supposed to tap into so I can finish this install over the weekend. If not, I'll call tech support on Monday and figure out why my instructions are wrong.
Thanks!